What to do if 4 LEDs blink on my Hilti SCM 22-A Saw?
If 4 LEDs are blinking on your Hilti Saw, it could be because the circular saw was overloaded briefly. Release the control switch and then press it again. Alternatively, the overheating prevention cut-out may have been activated. Allow the circular saw to cool down and clean the air vents.
How to fix Hilti SCM 22-A if chips fall onto the base plate?
If chips or cuttings from your Hilti Saw are not being transported into the chip collector and are falling onto the base plate, it could be because: * The chip collector is full. Empty the chip collector. * The chip ejector channel is blocked. Clean the chip ejector channel.
Why the LEDs on my Hilti Saw indicate nothing?
If the LEDs on your Hilti Saw aren't lighting up, it could be due to the following reasons: * The battery is not fully inserted. Push the battery in until it engages with a double click. * The battery is discharged. Replace the battery and charge the empty one.
To Next Page
General
