English 7
3.4 Active Torque Control – ATC
TE 70-ATC-AVR
TE 80-ATC-AVR
In addition to the mechanical slip clutch, this product also features ATC.
ATC detects sudden, uncontrolled rotation of the power tool about its own
axis and switches the tool off immediately. This can happen, for example, if
the accessory tool jams.
When ATC is activated the motor stops. Restart the power tool by releasing
the control switch and then pressing it again.
Note
Always choose a working position that allows your product to turn freely
counterclockwise. If this turning action is not possible, ATC cannot
react.
3.5 Service indicator
The combihammer has a service indicator LED.
Status Meaning
The service indicator lights red. • End of service interval – servicing
is due.
The service indicator blinks red. • Have the combihammer repaired
by Hilti Service.
3.6 Items supplied
Combihammer, side handle, operating instructions.
You can find other system products approved for your product at your local
Hilti Center or online at: www.hilti.com.
4 Technical data
4.1 Combihammer
Note
For details of the rated voltage, current, frequency and input power,
please refer to the power tool’s country-specific type identification plate.
If the tool is powered by a generator or transformer, the generator or
transformer’s power output must be at least twice the rated input power
shown on the rating plate of the tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the
rated voltage of the tool.
Printed: 02.02.2017 | Doc-Nr: PUB / 5150793 / 000 / 01
To Next Page
Loading...
Need help?
General
