CEM7 CONTROL UNIT INPUTS AND OUTPUTS | PAGE 32
5.7 EXPANSION PROGRAMMABLE OUTPUT
The CEM7 control unit has 4 additional programmable outputs installed in the
Second Zero Suppression expansion, the operation of which can be congured to
indicate certain states (Settings table, parameters 18 to 21). Of the 4 outputs
available, 2 (Programmable outputs 4 and 5) of them are directly connected at
the terminal and the other 2 (programmable outputs 6 and 7) must be requested
as a special function. The possible congurations permitted by the programmable
outputs are the same as those explained in section 5.6 Programmable outputs.
5.8 EXTERNAL INPUTS
The CEM7 control unit allows to assign CEC7 control unit and external devices
CCPT100 and CCIn8 digital inputs, to different functionalities, if those devices
are connected to the communications bus of the CEM7 control unit (Programmed
table, parameters 6 to 17, 22 to 23, 25 to 40, 46 to 48; values 17 to 48 -CCIn8
and CCPT100 modules inputs-, 53 to 67 -CEC7 control unit-).
To Next Page
Loading...
