Hioki IM3536-01 - Page 256

Appx.16
Initial Settings Table
Setting Items Default setting
Initialized initiated on
instrument
Initialization
initiated with
command
Reverts to default value
at power-on
Panel save/ Load
File save/ Load
*
RST
:PRESet
Basic settings
Number of times for average 1 ← ← ← No Yes Yes
Trigger delay 0.0000 s ← ← ← No Yes Yes
Trigger
synchronous
output
ON/OFF OFF ← ← ← No Yes Yes
Trigger time 0.0010 s ← ← ← No Yes Yes
AC range
synchronization
function
*1
Measurement speed MED ← ← ← No Yes Yes
Number of times for average 1 ← ← ← No Yes Yes
Trigger delay 0.0000 s ← ← ← No Yes Yes
Trigger
synchronous
output
ON/OFF OFF ← ← ← No Yes Yes
Trigger time 0.0010 s ← ← ← No Yes Yes
DC
measurement
(LCR mode)
DC adjustment ON ← ← ← No Yes Yes
DC delay 0.0000 s ← ← ← No Yes Yes
Adjustment delay 0.0030 s ← ← ← No Yes Yes
Line frequency 60 Hz ← ← ← No Yes Yes
Measurement
range
Mode AUTO ← ← ← No Yes Yes
AUTO range control
function
100 m
Ω
/100 M
Ω
← ← ← No Yes Yes
Range 100
Ω
← ← ← No Yes Yes
Judgment synchroni-
zation setting
OFF ← ← ← No Yes Yes
LOW Z OFF ← ← ← No Yes Yes
Measurement speed MED ← ← ← No Yes Yes
Number of times for average 1 ← ← ← No Yes Yes
DC range
synchronization
function
*1
Measurement speed MED ← ← ← No Yes Yes
Number of times for average 1 ← ← ← No Yes Yes
Application
settings
Judgment mode OFF ← ← ← No Yes Yes
Memory
OFF/IN/ON OFF ← ← ← No No Yes
Number of memory
items
1000 ← ← ← No No Yes
Range synchronization function OFF ← ← ← No Yes Yes
Waveform
averaging
function
ON/OFF OFF ← ← ← No Yes Yes
No. of waveform
averages for each
frequency band
Number of MED
waveform aver-
ages
← ← ← No Yes Yes