Hioki RM3548 - Chapter 5: Judgment and Conversion Functions; Judging Measured Values (Comparator Function)

Hope Electronics Technology Manual Edition V1.0 48
Chapter 5 Judgment and Conversion Functions
This chapter describes the measured value judgment and conversion
functions.
5.1 Judging Measured Values (Comparator Function)
This function judges a measured value to be Hi (measured value > upper
limit), IN (upper limit > measured value > lower limit), or Lo (lower limit >
measured value) against the set reference value, or upper or lower limit values.
The judgment result can be verified on screen, with the buzzer (factory
default is OFF), and the L2105 LED Comparator Attachment (option).
There are two different judgment methods available: ABS mode and REF%
mode.
Before using the comparator function
If no measured value appears, the comparator judgment is displayed as
follows: If a measurement error occurs, judgment is not performed
Display Comparator judgment display (COMP lamp)
IMPORTANT
l If AT or length conversion function is turned ON, the comparator function
automatically turns OFF.
l If the comparator function is set to ON, it becomes impossible to change the
range (including the auto range). To use the auto range or change the range,
set the comparator function to OFF, and then use the [AUTO] key or [▲][▼]
keys.
l If the comparator function is set to ON, the interval memory function
becomes unavailable.