Hope Electronics Technology Manual Edition V1.0 64
7.2 After stable measurement values automatically save
When a measured value stabilizes, the value is automatically held and
saved.
Press the [MODE] key to switch saving mode.
oFF→Auto-hold (A.HOLD) →Auto-memory (A.HOLD, A.MEMORY)
→Interval (INTERVAL) → oFF
Press the [ENTER] key to confirm the saving mode; press the [ESC] key to
cancel the selection.
The memory number is incremented by one each time data is saved, and
cannot be specified. If data is accidentally saved, clear the last data item saved
(latest data).
To Next Page
Loading...
