Hope Electronics Technology Manual Edition V1.0 8
Measurement precautions
To avoid electric shock accident and short
circuit, please operate the instrument as following:
Do not allow the instrument to get wet, and do
not use it with wet hands. This may cause electric
shock accident.
Do not modify, disassemble, or repair the
instrument. This may result in fire, electric shock
accident, or injury.
Do not place the instrument on an unstable or
slanted surface. It may drop or fall, causing injury or
instrument failure.
To avoid any damage to the instrument, avoid
any vibration or shock during transport or handling.
Especially, be careful not to drop or fall the
instrument which will cause shock.
To avoid any damage to the instrument, do not
input voltage or current to any measurement, TC
terminals, or EXPORT terminals.
Handling leads and cables
To avoid electrical shock accident, do not short
test leads where
voltage is applied.
Do not use any test lead or temperature sensor
other than the ones specified by our company. It
may result in inaccurate measurement due to poor
contact or other reasons.
To avoid damaging the cables, do not bend or
pull the base of cables and the leads.
The ends of pin type leads are sharp. Be careful
to avoid injury.
Be careful not to allow contact between the lead
wire and the heat generating portion.
To Next Page
Loading...
Need help?
General
