Network load control
12
8.2
Multicast application
Basic - L3P
Release
4.0
11/07
Settings per port (table)
X IMGP on per port
This table column enables you to enable/disable the IGMP for each
port when the global IGMP Snooping is enabled. Disabling the IGMP
at a port prevents registration for this port.
X IGMP Forward All per port
This table column enables you to enable/disable the "Forward All"
IGMP Snooping function for each port when the global IGMP Snoop-
ing is enabled. With the "Forward All" function, the Switch sends to
this port all data packets with a Multicast address in the destination
address field.
Note: If a number of routers are connected to a subnetwork, you
must use IGMP version 1 so that all the routers receive all the
IGMP reports.
Note: If you are using IGMP version 1 in a subnetwork, you must
also use IGMP version 1 in the entire network.
X IGMP Automatic Query Port
This table column shows you which ports the Switch has learned as
query ports, if "automatic" is selected in "Static Query Port".
X Static Query Port
A Switch sends IGMP report messages to the ports at which it re-
ceives IGMP queries. This column allows you to also send IGMP re-
port messages to other selected ports.
X Learned Query Port
This table column shows you at which ports the Switch has received
IGMP queries, if "disable" is selected in "Static Query Port".
To Next Page
Loading...
Need help?
General
