Entering the IP Parameters
Basic - L3P
Release
4.0
11/07
2.9
Faulty device replacement
27
2.9 Faulty device replacement
The Switch provides two plug-and-play solutions for replacing a faulty Switch
with a Switch of the same type (faulty device replacement):
X Configuring the new Switch via an AutoConfiguration Adapter (see on
page 14 "Loading the system configuration from the ACA") or
X Configuration via DHCP Option 82 (see on page 206 "Setting up DHCP
Server Option 82").
In both cases, when the new Switch is started, it is given the same configu-
ration data that the faulty Switch had.
Note: If you replace a Switch with DIP switches, please ensure that the DIP
switch settings are identical.
To Next Page
Loading...
