Hirschmann MACH 4000 User Manual

Operation diagnosis
Basic - L3P
Release 4.0 11/07
9.1 Sending traps
3
9.1.1 SNMP trap listing
All the possible traps that the Switch can send are listed in the following table.
Trap name Meaning
authenticationFailure is sent if a station attempts to access an agent without permission.
coldStart is sent for both cold and warm starts during the boot process after
successful management initialization.
hmAutoconfigAdapterTrap is sent when the ACA Auto Configuration Adapter is removed or
plugged in again.
linkDown is sent if the link to a port is interrupted.
linkUp is sent as soon as the link to a port is re-established.
hmTemperature is sent if the temperature exceeds the set threshold value.
hmPowerSupply is sent if the status of the voltage supply changes.
hmSigConRelayChange is sent if the status of the signal contact changes during the oper-
ation monitoring.
newRoot is sent if the sending agent becomes a new root of the spanning
tree.
topologyChange is sent if the transmission mode of a port changes.
risingAlarm is sent if an RMON alarm input exceeds the upper threshold.
fallingAlarm is sent if an RMON alarm input falls below the lower threshold.
hmPortSecurityTrap is sent if a MAC/IP address is detected at the port which does not
correspond to the current settings of – hmPortSecPermission and
– hmPorSecAction set either to trapOnly (2) or portDisable (3).
hmModuleMapChange is sent if the hardware configuration is changed.
hmBPDUGuardTrap is sent if a BPDU is received at a port even though the BPDU
Guard function is active.
hmMrpReconfig is sent if the configuration of the MRP-Ring changes.
hmRingRedReconfig is sent if the configuration of the HIPER-Ring changes.
hmRingRedCplReconfig is sent if the configuration of the redundant ring/network coupling
changes.
hmSNTPTrap is sent if errors occur in connection with the SNTP (e.g. server can-
not be reached).
hmRelayDuplicateTrap is sent if a duplicate IP address is detected in connection with
DHCP Option 82.
lldpRemTablesChange-
Trap
is sent, if an entry in the topology table is changed.
vrrpTrapNewMaster is sent if a different router becomes the master for an interface or
a virtual address.
vrrpTrapAuthFailure is sent if the router receives a packet with invalid authentication
from another VRRP router.
Table 14: Possible traps

Hirschmann MACH 4000 Specifications

General

Brand	Hirschmann
Model	MACH 4000
Category	Network Router
Language	English