Loading software updates
Basic - L3P
Release
4.0
11/07
4.1
Loading the software from the ACA
5
Test stored images in USB memory
Select 4 to check whether the images of the software stored in the
ACA 21-USB contain valid codes.
Apply and store selection
Select 5 to confirm the software selection and to save it.
Cancel selection
Select 6 to leave this dialog without making any changes.
4.1.2 Starting the software
This menu item (Start Selected Operating System) of the system monitor al-
lows you to start the software selected.
4.1.3 Performing a cold start
This menu item (End (reset and reboot)) of the system monitor allows you to
reset the hardware of the Switch and perform a restart.
To Next Page
Loading...
