Loading/saving settings
Basic - L3P
Release
4.0
11/07
3.1
Loading settings
3
3.1.1 Loading from the local non-volatile memory
When loading the configuration data locally, the Switch loads the configura-
tion data from the local non-volatile memory if no ACA is connected to the
Switch.
3.1.2 Loading from the AutoConfiguration Adapter
If an ACA is connected to the Switch, the Switch always loads its configura-
tion from the ACA.
The chapter "Saving locally (and on the ACA)" on page 7 describes how to
save a configuration file on an ACA.
Select the
Basics: Load/Save dialog.
In the "Load" frame, click "Local".
Click "Load configuration".
enable Switch to the Priviledged EXEC mode.
copy nvram:startup-config
system:running-config
The Switch loads the configuration data from the
local non-volatile memory.
To Next Page
Loading...
Need help?
General
