Entering the IP Parameters
26
2.8
System configuration via the Web-based in-
Basic - L3P
Release
4.0
11/07
Enter the parameters on the right according to the selected mode.
You enter the name applicable to the DHCP protocol in the "Name" line in
the system dialog of the Web-based interface.
The "VLAN ID" frame enables you to assign a VLAN to the agent. If you
enter the illegal VLAN ID "0" here, the agent can be accessed by all
VLANs.
The HiDiscovery protocol allows you to assign an IP address to the switch
on the basis of its MAC address. Activate the HiDiscovery protocol if you
want to assign an IP address to the Switch from your PC with the enclosed
HiDiscovery software (see page 11 "Entering the IP Parameters via Hi-
Discovery") (setting on delivery: active).
Note: Save the settings so that you will still have the entries after a restart
(see page 53 "Loading/saving settings").
To Next Page
Loading...
