Setting up configuration environment
10
A.2
Setting up DHCP Server Option 82
Basic - L3P
Release
4.0
11/07
Figure 74: Default setting for the fixed address assignment
In the Hardware address field, you enter the Circuit Identifier
and the Remote Identifier (see "DHCP Relay Agent" in the "Web-
based Interface" reference manual). With Hardware address you iden-
tify the Switch and the port to which that device is connected, to which you
want the assign the IP address in the line below it.
The hardware address is in the following form:
ciclhhvvvvssmmpprirlxxxxxxxxxxxx
X ci: sub-identifier for the type of the circuit ID
X cl: length of the circuit ID
X hh: Hirschmann ID: 01 if a Hirschmann Switch is connected to the port,
otherwise 00.
X vvvv: VLAN ID of the DHCP request (default: 0001 = VLAN 1)
X ss: socket of Switch at which the module with that port is located to
which the device is connected. Enter the value 00.
X mm: module with the port to which the device is connected.
X pp: port to which the device is connected.
X ri: sub-identifier for the type of the remote ID
X rl: length of the remote ID
X xxxxxxxxxxxx: remote ID of the Switch (e.g. MAC address) to which a
device is connected.
To Next Page
Loading...
Need help?
General
