Entering the IP Parameters
Basic - L3P
Release
4.0
11/07
2.3
Entering the IP Parameters via HiDiscovery
13
Figure 11: HiDiscovery - assigning IP parameters
Note: When the IP address is entered, the Switch copies the local configura-
tion settings (see on page 53 "Loading/saving settings").
Note: For security reasons, switch off the HiDiscovery function for the device
in the Web-based interface, after you have assigned the IP parameters to the
device (see page 25 "System configuration via the Web-based interface").
Note: Save the settings so that you will still have the entries after a restart
(see on page 53 "Loading/saving settings").
To Next Page
Loading...
Need help?
General
