Entering the IP Parameters
Basic - L3P
Release
4.0
11/07
2.5
System configuration via BOOTP
17
switch_01:ht=ethernet:ha=008063086501:ip=149.218.112.83:tc=.global:
switch_02:ht=ethernet:ha=008063086502:ip=149.218.112.84:tc=.global:
.
.
Lines that start with a '#' character are comment lines.
The lines under ".global:" make the configuration of several devices easier.
With the template (tc) you allocate the global configuration data (tc=.global:)
to each device .
The direct allocation of hardware address and IP address occurs in the de-
vice lines (switch-0...).
Enter one line for each device.
After ha= enter the hardware address of the device.
After ip= enter the IP address of the device.
In the appendix under "Setting up DHCP/BOOTP server" on page 200 you
will find an example for the configuration of a BOOTP/DHCP server.
To Next Page
Loading...
