Entering the IP Parameters
20
2.5
System configuration via BOOTP
Basic - L3P
Release
4.0
11/07
Note: The loading process started by DHCP/BOOTP (see on page 16 "Sys-
tem configuration via BOOTP") shows the selection of "from URL & save lo-
cally" in the "Load" frame. If you get an error message when saving a
configuration, this could be due to an active loading process. DHCP/BOOTP
only finishes a loading process when a valid configuration has been loaded.
If DHCP/BOOTP does not find a valid configuration, then finish the loading
process by loading the local configuration in the "Load" frame.
To Next Page
Loading...
