20
Installation MACH104
Release
08
01/2019
1.3.3 MACH104-20TX-F-4-PoE...
Supply voltage is connected via a non-heating appliance socket.
Figure 6: MACH104-20TX-F-4-PoE... connections on the back of the device
1 - Standard power supply 100 V AC ... 240 V AC
2 - MACH104-20TX-F-4-PoE... device
1.4 Ethernet ports
You can connect end devices and other segments to the device ports using
twisted pair cables or optical fibers (F/O).
1.4.1 10/100/1000 Mbit/s twisted pair port
This port is an RJ45 socket.
The 10/100/1000 Mbit/s twisted pair port allows you to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX/
1000BASE-T standard.
This port supports:
Autonegotiation
Autopolarity
Autocrossing (if autonegotiation is activated)
1000 Mbit/s full duplex
100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
Note: Some of these ports also support Power over Ethernet (PoE).
See “PoE ports” on page 21.
Delivery state: Autonegotiation activated
The port casing is electrically connected to the front panel.
The pin assignment corresponds to MDI-X.
To Next Page
Loading...
