32
Installation MACH104
Release
08
01/2019
2.5 Operating the device
Note: Note the safety instructions in “Requirements for connecting electrical
wires” on page 6.
By connecting the voltage supply via the voltage supply socket(s), you start
the operation of the device.
2.6 Connecting data cables
Note: Verify that you connect only optical ports with the same optical
transmission properties with each other.
Further information:
See “Ethernet ports” on page 20.
Connect the data cables according to your requirements.
WARNING
ELECTRIC SHOCK
Connect only a supply voltage that corresponds to the type plate of your
device.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.