34
Installation MACH104
Release
08
01/2019
3.1 Default settings
The device looks for the IP address using DHCP
Management password:
user, password: public (read only)
admin, password: private (read and write)
V.24 data rate: 9600 Baud
Ring redundancy disabled
Ethernet ports: link status is not evaluated (signal contact)
Optical 100 Mbit/s ports: 100 Mbit/s full duplex
Other ports: Autonegotiation
Redundancy manager disabled
(DIP switch RM and Standby: ON)
Standby coupling disabled
(DIP switch RM and Standby: ON)
Port 3 = control port, Port 4 = coupling port for redundant ring coupling
Rapid Spanning Tree enabled
To Next Page
Loading...
