30
Installation MACH104
Release
08
01/2019
Figure 12: Assembly in a switch cabinet with sliding/mounting rails
1 - MACH104 device
2 - sliding/mounting rail
3 - 19" switch cabinet
Figure 13: Mounting the MACH104 in the 19" cabinet
Fasten the device by screwing the brackets to the switch cabinet.
Note: When operating the device in an environment with strong vibrations,
you have the option to additionally fasten the device to the switch cabinet
using 2 holding brackets on the back of the device.
You obtain the additional brackets as accessories.
See “Accessories and order numbers” on page 44.
2.4.4 Mounting on the wall
Remove the screws on the pre-installed mounting brackets.
Move the two pre-installed mounting brackets into the position shown
below.
Use the screws to secure the mounting brackets on the device.
To Next Page
Loading...
