① Seat belt
2. Selecting light switch position.
■ Head Lights Switch
Turn on the key switch and toggle the head
light switch to the “ON” position.
Toggle the head light switch to the “OFF”
position to turn off the head light.
① Head light switch
⑫ Emergency light "OFF"
⑬ Winch cable release
⑭ Winch cable pulled up
NOTE:
Turning the head light switch to the “ON”
position causes the following lamps to light
simultaneously.
1. Tail lights (lamps at the rear portions of
the vehicle)
2. Lamp built in the coolant temperature
gauge
3. Lamp built in the fuel gauge
4. Lamp built in the speedometer
5. Front left and right position lights
■ Emergency Light Switch
Press the top half of the emergency light
switch, the light flash along with the indicator
on the instrument panel. Press the bottom
half of the emergency light switch to turn off
the light.
Note:
The emergency light switch will operate
when the key switch is in the “ON”
position. Be careful that keeping the
switch “ON” causes the battery to run
out.
■ Turn Signal Light Switch
[if equipped]