EasyManua.ls Logo

Hisun HS294-2 - Every 400 Hours; Changing Transmission Fluid; Changing Front and Rear Axle Case Oil

Hisun HS294-2
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Tire Tread Depth
Always replace the tires when the tread depth
is worn to minimum allowable.
3mm(0.12in)
EVERY 400 HOURS
Changing Transmission Fluid
CAUTION
To avoid personal injury:
Park the vehicle on a flat surface, raise
the cargo bed, mount the safety
support.
Allow engine to cool down sufficiently,
oil can be hot and can burn.
1. Park the vehicle on a flat surface, raise the
cargo bed, mount the safety support.
2. To drain the used oil, remove the drain plug
at the bottom of the transmission case and
drain the oil completely into the oil pan.
3. After draining, reinstall the drain plug.
4. After running the engine for a few minutes,
stop the engine and check the
oil level
again; add oil to prescribed level.
Drain plug
IMPORTANT:
Do not operate the vehicle immediately
after changing the transmission fluid.
Run the engine at medium speed for a few
minutes to prevent damage to the
transmission.
Changing Front and Rear Axle Case Oil
1. Park the vehicle on a firm, flat and level
surface.
2. To drain the used oil, remove the drain the
oil completely into the oil pan.
3. Fill with the new oil up to the upper notch
on the dipstick.
(See “LUBRICANTS, FUEL AND
COOLANT” in “MAINTENANCE” section.)
4. After filling, reinstall the filling plug.

Table of Contents

Related product manuals