① Recovery tank ②“ FULL”
③ “ LOW”
IMPORTANT:
⚫ Do not start engine without coolant.
⚫ Use clean, fresh water and anti-freeze to fill
the radiator and recovery tank.
⚫ When the anti-freeze is mixed with water,
the antifreeze mixing ratio must be less
than 50%.
⚫ Securely tighten radiator cap. If the cap is
loose or improperly fitted, water may leak
out and the engine could overheat.
■ Anti-Freeze
CAUTION
⚫ Do not mix different types of Antifreeze.
The mixture can produce chemical
reaction causing harmful substances.
⚫ Antifreeze is extremely flammable and
explosive under certain conditions. Keep
fire and children away from antifreeze.
When draining fluids from the engine, place
some container underneath the engine
body.
⚫ Do not pour waste onto the grounds, down
a drain, or into any water source.
⚫ Also, observe the relevant environmental
protection regulations when disposing of
antifreeze.
If it freezes, coolant can damage the cylinders
and radiator. If the ambient temperature falls
below 0℃(32
°
F) or before a long-term storage,
let out cooling water completely, or mix fresh
water with long-life coolant and fill the radiator
and recovery tank with the mixture.·
1. Long-life coolant (hereafter LLC) comes in
several types. Use ethylene glycol(EG)
type for this engine.
2. Before employing LLC-mixed cooling
water, fill the radiator with fresh water and
empty it again.
Repeat this procedure 2 or 3 times to
clean up the inside.
3. Mixing the LLC
4. The procedure for the mixing of water and
antifreeze differs according to the make of
the antifreeze and the ambient
temperature. Refer to SEA J1034
standard, more specifically also to SAE
J814c.
To Next Page
Loading...
Need help?
General
