Hisun HS294-2 - Replacing Engine Oil Filter; Replacing Transmission Oil

Hitch coupling device
12-80
drain the oil into an oil pan.
3. After draining, reinstall the drain plug.
4. Fill with the new oil up to the upper notch
on the dipstick.
(See “LUBRICANTS, FUEL AND
COOLANT” in “MAINTENANCE” section.)
Oil capacity
[Filter exchanged]
1.8L (1.89U.S. qts.)
[Filter non-
exchanged]
1.6L (1.68U.S. qts.)
① Oil Leve
② Dipstick
■ Replacing Engine Oil Filter
CAUTION
the mounting surface. Tighten filter by
hand an additional 1/2 turn only.
5. After the new filter has been replaced, the
engine oil normally decreases a little. Make
sure that the engine oil does not leak
through the seal and check the oil level on
the dipstick. Then replenish the engine oil
up to the prescribed level.
① Bolt; ② Cover
③ “O” seal ring; ④ Engine oil filter
IMPORANT:
⚫ To prevent serious damage to the engine,
use only a genuine filter.
■ Replacing Transmission Oil
CAUTION
To avoid personal injury:
⚫ Be sure to stop the engine before
changing oil.