Hitachi Compute Blade 500 Series - Interface Port Pin-Outs; USB Connector; RS-232 C Interface Connector (Management Module)

Items Specifications
Cable type Twinax
Cable length 1 m 3 m 5 m
Regulatory compliance Complies with IEEE802.3ae
Interface Port Pin-outs
This section describes interface port pin-outs.
USB Connector
The following figure shows USB connector installed in the front panel and
server blades.
Figure 2-1 USB Connector
Table 2-34 USB connector pin-out
Pin Signal Name Description Direction
1 VBUS +5V supply voltage Output
2 D - Data- signal line Input / Output
3 D + Data+ signal line Input / Output
4 GND Supply Ground -
RS-232C Interface Connector (Management Module)
The following figure shows RS-232C interface connector installed in
management modules.
Figure 2-2 RS-232C Interface Connector
Specification
2-23
Hitachi Compute Blade 500 Series System Overview Guide