Hitachi EH-150 - Chapter 4 System Equipment; Name and Function of Each Parts

Chapter.4 System equipment
4-1
Chapter 4 System equipment
Name and function of each parts Type
EH-ETH2
Weight
0.12 kg (0.26 Lb.)
Dimensions (mm (in.))
1) LED cover
7) Lock button
3) Reset switch
4) Dip switch
6) Ethernet connector
2) E.CLR switch
5) RS-232C connector
LIN
K
Transfer
speed
No. Name Function Remarks
1) LED cover Refer to “Section 4.2 LED indications” for details.
2) E.CLR switch Used to clear error.
3) Reset switch Used to restart the module.
4) Dip switch Used to set operation mode.
5) RS-232C connector No use.
6) Ethernet connector
RJ45 type connector.
[LINK LED] Green: Cable is connected.
[Transfer speed LED] Orange: 10Mbps Green: 100Mbps
7) Lock button
When dismounting the module from a base unit, press this button and lift up the module.
If necessary, the module can be fixed using a screw (M4, 10mm) after installation on the
base unit.