Hitachi EH-150 - Ethernet Parameters Setting Error Code

Chapter 5 Configuration of Communication parameters
5.2.8 Ethernet parameters setting error code
The list of error code of Ethernet parameters setting is shown in
Table 5.8.
Table 5.8 The list of error code during the IP address setting
Error
Code
Display comment Causes
1001 Operation mode: Is not Configuration mode. The position of dip switch is not for “Configuration mode”.
1101 Own station address: IP address is incorrect. - Illegal value or character is set for IP address.
- “0.0.0.0” or “255.255.255.255” is set for IP address.
1102 Own station address: Subnet mask is
incorrect.
- Illegal value or character is set for Subnet mask.
- The out of value of “255.0.0.0” to “255.255.255.248” is set
for Subnet mask.
1103 Own station address: Default Gateway
address is incorrect.
- Illegal value or character is set for Default gateway address.
- “255.255.255.255” is set for Default gateway address.
1104 Own station address: IP address or Subnet
mask is incorrect.
“255.255.255.255” is set for Subnet mask..
1201 Test mode: IP address is incorrect. “0.0.0.0” or “255.255.255.255” is set for IP address of other
station for Diagnosis.
1202 Test mode: Port No. is incorrect. Illegal value or character is set for port number of other
station for Diagnosis.
1203 Test mode: Port No. is in conflict with ASR
connection m
(*1)
.
The port number of other station for Diagnosis and the port
number of ASR connection m
(*1)
is in coincidence(conflict).
1301 Task code communication (No. p
(*2)
): Port
No. is incorrect.
Illegal value or character is set for task code port number.
1303 Task code communication: Timeout is
incorrect.
Illegal value or character is set for task code time out
number.
1305 Task code communication: Port No. conflict
with ASR connection m
(*1)
.
The port number of task code and the port number of ASR
connection m
(*1)
is in coincidence (conflict).
1306 The setting of Transfer Speed / Type is
incorrect.
The setting of Transfer Speed / Type is out of valid range.
*1: m should be in 1 to 6.
*2: p should be in 1 to 4.
5-10