Chapter 5 Configuration of Communication parameters
5.2.2 Configuration
Please connect PC and HUB, HUB and EH-ETH2 with LAN cable.
The example in
Figure 5.2 shows the smallest network by the explanation for convenience.
HUB
PC
PLC / EH-ETH2
Figure 5.2 Example of network
5.2.3 Network Setting on PC side
At the network configuration of Figure 5.2, to access EH-ETH2 Configurator, the setting of PC must be the
below condition.
1) Subnet mask is 255.255.255.0.
2) IP address's top-3 octets is 192.168.0 and 4th octet is not duplicated the EH-ETH2’s.
(*1)
*1: EH-ETH2 IP address 4th octet is set by dipswitch 4 to 8.
Tentatively, in case of subnet mask is 255.255.255.0 at PC side, and IP address is 192.168.0.128,
you do not need to set network setting at PC side. (Recommended value)
On the other hand, in case of subnet mask is 255.255.0.0, and IP address is 172.16.0.128,
you need to change the network setting on PC.
5-3
To Next Page
Loading...
