Deskstar 7K500 and Deskstar E7K500 Hard Disk Drive Specification
212
12.42.8 Error reporting
The following table shows the values returned in the Status and Error Registers when specific error conditions are
encountered by a device.
Table 161: S.M.A.R.T. Error Codes
Error condition Status Register Error Register
A S.M.A.R.T. FUNCTION SET command was received by the device
without the required key being loaded into the Cylinder High and Cylin-
der Low registers.
51h 04h
A S.M.A.R.T. FUNCTION SET command was received by the device
with a subcommand value in the Features Register that is either invalid
or not supported by this device.
51h 04h
A S.M.A.R.T. FUNCTION SET command subcommand other than
S.M.A.R.T. ENABLE OPERATIONS was received by the device while
the device was in a "S.M.A.R.T. Disabled" state.
51h 04h
The device is unable to read its Attribute Values or Attribute Thresholds
data structure
51h 10h or 40h
The device is unable to write to its Attribute Values data structure.
51h 10h or 01h
To Next Page
Loading...
