Hitachi Hi8 VM-H70E - Simple Programmable Edit.41

SIMPLE PROGRAMMABLE EDIT
Simple programmable edit allows you to programme your camera/recorder to select the scenes you
want to copy from a pre-recorded tape. Use the edit remote control (optional with the VM-H70E or pro¬
vided with the VM-H71E) to easily copy scenes from a recorded tape in the camera/recorder (playback
machine) onto a blank tape in a table-top VCR which handles infrared remote signals (recording
machine).
Source
tape
Copied
tape
Start End Start
End Start End
PROG. 1 PROG. 2
PROG. 3
■ How to install the batteries
• Do not use the old and new batteries at the
same time.
• Do not mix batteries of different types.
• Do not short, take apart or dispose of batteries
by throwing them into a fire.
• When liquid leaks, wipe it off completely and
then insert new batteries.
■ Remote controllable range
Cautions on the remote control
• Point the remote control straight at the VCR's
infrared receiver for operation.
• Use the remote control indoors. When the
infrared receiver is exposed to direct sunlight
or strong light such as that from artificial light¬
ing, the remote control may not operate cor¬
rectly.
• The remote control cannot be operated if there
is an obstacle between the remote control and
infrared receiver. Especially, be careful of this
during dubbing.