Hitachi Hi8 VM-H70E User Manual

WATER-RESISTANT
■ Water-resistant structure
Your camera/recorder uses three packings as
shown below to provide a water-resistant struc¬
ture.
Water-resistant Packing
• To check the packing
1. Open the case so the end of the bracket
is positioned as shown in the figure and
pull the bracket forward to release it.
2. After checking, replace the bracket to its
original position.
CAUTION
■ How to handle the water-resistant pack¬
ings
• Inspect the water-resistant packings con¬
stantly to check that there are no scratches
or chipping as they could cause water to
enter.
• Check that no foreign matter adheres to the
water-resistant packings before closing the
cases. If the camera/recorder is used while
dust, sand or thread adheres to only one
point of the packings, it could cause water
to enter.
• The water-resistant packings are expend¬
able supplies.
it is recommended to replace them once a
year.
• Consult your nearest dealer to replace the
packings.
■ The camera/recorder cannot be used in the
following places
• Underwater
• In a place at high temperature and high
humidity such as in a sauna, bathroom, etc.
• Where water would strike it violently
(where water pressure is applied)
NOTE: The camera/recorder cannot be
used under water because it is not water¬
proof.
■ Be careful when opening and closing the
sections with packing
• The camera/recorder inside the case is not
structured to be water-resistant. Take great
care that no water droplets enter inside.
• Check that the three sections with packing
are closed tightly to ensure that it is water-
resistant.
3

Hitachi Hi8 VM-H70E Specifications

General

Brand	Hitachi
Model	Hi8 VM-H70E
Category	Measuring Instruments
Language	English