Press 2nd screen and switch Count conditions screen.
Input "I" and "Q" at "Count skip" on the 2nd screen of Count conditions.
5
Count conditions
screen switching
Count skip
Skip the characters inputted to "Count skip", then print the next count value.
See the figure below for print example.
6
● When the "Count character" is added, overwritten or deleted, the confirmation
message "Changed skip condition" shows up on the screen and "Count skip"
character becomes invalid.
● As to Range (maximum), input either one kind of capital alphabetical character, small
alphabetical character or user pattern.
In addition, all "Count skip" characters must be included in the smallest range.
● Characters which were set as Value, Range, Jump or Reset cannot be input to "Count
skip".
● When the "Count skip" is set, the incremental value is 1=fixed.
Precautions when using count skip printing
To Next Page
Loading...
Need help?
General
