Hitachi IJ UX - Page 246

9-9 ●On-screen message descriptions
No. Message Meaning of message Remedy
52
Target Sensor Time
Out
The print target detecter signal was ON
longer than the timeout setting of Target
Sensor Timer.
● If the target is stopped in front
of the sensor, move the target.
● Change the Target Sensor
Timer setting.
( 4.14.1).
53
Target Spacing Too
Close
There are 5 or more print target detector
signal turned ON before print start during
printing at No repeat print setting.
● Move the print target detecter
closer to the print head.
54
Print Data
Changeover In
Progress S
A print operation was requested while the
print data was being changed.
● If the target signal is
chattering, Use Sensor filter
setting.
● Change of timing either print
data change or print start.
56 Blank Print Items The print items are not properly set up. ● Change the print data.
57
Excessive Format
Count
A column has more than 8 print format
types (the number of lines, line spacing,
character size, character spacing, bold
charcter and bar code).
● Perform setup so that the
number of print format types
does not exceed 8.
58
Print Data
Changeover In
Progress M
A print operation was requested while the
print data was being changed.
● Change timing of either print
data change or print start.
59
Print Data
Changeover In
Progress V
A print operation was requested while the
video data was being changed.
● Adjust either the encoder
frequency or the pulse rate
division factor.
● Change timing of either print
data change or print start.
60
Communication
Buffer Fault
The print contents are not in the
communication buffer.
.● Adjust the print and
communication timing.
62
Internal
Communication
Error C
The internal data processing error.
● Ink stop and the printer power
OFF are recommend.
Turn the printer OFF and then
back ON after 10 seconds.
63
Internal
Communication
Error M
The internal data processing error.
● Ink stop and the printer power
OFF are recommend.
Turn the printer OFF and then
back ON after 10 seconds.
245
Ink Level Sensor
Broken 1
The l
evel sensor in the ink reservoir does
not work properly.
● Contact your nearest local
distributor.
246
Makeup Level
Sensor Broken 1
The level sensor in the makeup reservoir
does not work properly.
The replacement of the Makeup Cartridge
will be temporarily disabled until “Makeup
Low Waring” appears.
● Contact your nearest local
distributor.
254
Ink Level Sensor
Broken 3
The level sensor in the ink reservoir does
not work properly.
● Contact your nearest local
distributor.
255
Makeup Level
Sensor Broken 3
The level sensor in the makeup reservoir
does not work properly.
● Contact your nearest local
distributor.