Hitachi IJ UX User Manual

9-11 ●On-screen message descriptions
No. Message Meaning of message Remedy
85
Ambient
Temperature Too
Low
The ambient temperature is below the
proper level.
● Ensure that the ambient tem-
perature is within the operat-
ing temperature limits.
87 Ink Pressure High
Ink pressure is higher than the
recommended value.
● Adjust the pressure-reducing
valve to correct the pressure.
( Technical manual 6.9)
88 Battery Low C
The internal battery in controller section is
low.
● Contact your nearest local
distributor.
● Replace the internal battery
in engine section and set the
data/time. ( 6.2).
93 Ink Pressure Low
Ink pressure is lower than the
recommended value..
● Adjust the pressure-reducing
valve to correct the pressure.
( Technical manual 6.9)
95
Product Speed
Matching Error
The encoder pulse rate exceeds the
available printing speed.
● Slow the print target speed.
● Decrease N in the ink drop
use percentage (1/N).
( 4.14.1).
129 Model-key Failure Model-key recognition failed.
● Contact your nearest local
distributor.
130
Language-key
Failure
Language-key recognition failed.
● Contact your nearest local
distributor.
131 Upgrade-key Fault Upgrade-key recognition failed.
● Contact your nearest local
distributor.
135
Circulation System
Cooling Fan
Fault
The cooling fan of the circulation system
area is faulty.
● Contact your nearest local
distributor.
136
Inside Temperature
Too High
The temperature inside the printer is
increasing.
● Prease confirm the ink
recovery status.
● Replace the air filter or make
the space around printer.
● Contact your nearest local
distributor.
151
RFID Reader
Failure
RFID reader recognition failed.
● Contact your nearest local
distributor.
152
Makeup Ejection
Pressure Low
Makeup ejection pressure is getting low.
● Contact your nearest local
distributor.
161
Ink Level
Sensor Broken 2
The level sensor in the ink reservoir does
not work properly.
If IJ printer continues
running as it is,
IJ printer will regard it as "Ink low " and
stop the ink jet.
● Contact your nearest local
distributor.
162
Makeup Level
Sensor Broken 2
The level sensor in the makeup reservoir
does not work properly.
If IJ printer continues running as it is,
IJ printer will regard it as "Makeup low "
and stop the ink jet.
● Contact your nearest local
distributor.

Hitachi IJ UX Specifications

General

Brand	Hitachi
Model	IJ UX
Category	Printer
Language	English