Hitachi IJ UX - Page 36

3-9 ●Start operation
TEST
STARTPRINTING STARTUP
SETTINGS LOGIN
Ink Jet Startup Confirmation No.050
CONFIRMATION
×
The ink jet will be turned ON.
Solution 1. To change the printer status to Ready, press <Ready>.
2. To change the printer status to Standby, press <Eject ink>.
Ready CancelEject ink
Use this procedure when you want to eject ink from the nozzle for a purpose other than printing.
(Use only during maintenance. To print, press the STARTUP → Ready .
Press the STARTUP → Eject ink .
Ink ejection for maintenance
● Operation can be aborted by pressing the Cancel at the “Ink Jet Startup Confirmation message”.
● If the print head cover installed, the printer will not enter the Ready state even if this operation is
performed. (Enters the Standby state)
Press Eject ink .
Press STARTUP .