Hitachi L700 Series

Chapter 2 Installation and Wiring
2 - 13
(2) Layout of main circuit terminals
The figures below show the terminal layout on the main circuit terminal block of the inverter.
Terminal layout Inverter model
RB
R
(L1)
S
(L2)
T
(L3)
PD
(+1)
P
(+)
N
(‑)
U
(T1)
V
(T2)
W
(T3)
R0 T0
チャージランプ
PD‑P短絡片
DCLを使用しない場合、
PD‑P短絡片を取り外さ
ないでください。
G
EMCフィルタ機能
切り替え用短絡片
(斜線部)付き接地端子
G
L700-110LFF
L700-110HFF
R0 and T0: M4
Ground terminal: M5
Other terminals: M5
L700-150LFF
L700-150HFF
R0 and T0: M4
Ground terminal: M5
Other terminals: M6
RB
R
(L1)
S
(L2)
T
(L3)
PD
(+1)
P
(+)
N
(‑)
U
(T1)
V
(T2)
W
(T3)
R0 T0
GG
L700-185 to
L700-220LFF
L700-185 to
L700-300HFF
R0 and T0: M4
Ground terminal: M6
Other terminals: M6
L700-300LFF
R0 and T0: M4
Ground terminal: M6
Other terminals: M8
[Method of enabling/disabling the EMC filter function]
Charge lamp
Jumper connecting
terminals PD and P
Ground terminal with
jumper (shaded in the
figure) to enable/disable the
EMC filter function
When not using the DCL,
do not remove the jumper
from terminals PD and P.
Enabling the EMC filter
Disabling the EMC filter
(factory setting)
Disabling the EMC filter
(factory setting)
Enabling the EMC filter
Jumper
connecting
terminals PD
Ground terminal with jumper (shaded in the
figure) to enable/disable the EMC filter function
[Method of enabling/disabling the EMC filter function]
When not using the DCL,
do not remove the jumper
from terminals PD and P.
Charge lamp