Hitachi MULTIZONE RAM-53NE3F - Page 4

CONTENTS
2
9.4
HOW TO CHANGE THE INTERMITTENT FAN CONTROL SETTING _____________________________ 9-5
9.5 HOW TO CHANGE THE FAN SPEED IN COOLING MODE DURING THERMO OFF _________________ 9-6
9.6 SETTING THE PREVENTION OF MUTUAL INTERFERENCE ___________________________________ 9-7
9.7 ERROR CODE INFORMATION ___________________________________________________________ 9-8
9.7.1 HOW TO DISPLAY ERROR CODE_________________________________________________________ 9-8
9.7.2 HOW TO REMOVE ERROR CODE ________________________________________________________ 9-9
9.8 ADDITIONAL FUNCTION VIA DIP-SWITCH SETTINGS _______________________________________ 9-10
9.8.1 AUTO RESTART FUNCTION ____________________________________________________________ 9-10
9.8.2 HEATING/COOLING ONLY MODE SELECTION _____________________________________________ 9-10
10 OPTION LIST _________________________________________________________________________ 10-1
10.1 WIRED REMOTE CONTROL SPX-RCDB __________________________________________________ 10-2
10.1.1 SHIFT VALUE ________________________________________________________________________ 10-3
10.1.2 ERROR CODE INFORMATION __________________________________________________________ 10-4
10.3 WIRED FULL DOT REMOTE – SPX-WKT3 _________________________________________________ 10-7
10.3.1 NAMES AND FUNCTIONS OF REMOTE CONTROLLER ______________________________________ 10-7
10.3.2 SERVICE MENU ______________________________________________________________________ 10-8
10.3.3 SHIFT VALUE CHANGE ________________________________________________________________ 10-9
10.3.4 OPERATION LOCK ___________________________________________________________________ 10-10
10.3.5 INTERMITTENT FAN CONTROL ________________________________________________________ 10-11
10.3.6 FAN SPEED DURING THERMO OFF ____________________________________________________ 10-12
10.2 H-LINK ADAPTOR – PSC 6RAD _________________________________________________________ 10-13
10.2.1 SAFETY SUMMARY __________________________________________________________________ 10-13
10.2.2 INSTALLATION WORK ________________________________________________________________ 10-13
10.2.3 ELECTRICAL WIRING _________________________________________________________________ 10-14
10.2.4 DIP SWITCH SETTING ________________________________________________________________ 10-15
10.2.5 TEST RUN __________________________________________________________________________ 10-16
10.3 DRY CONTACT (SPX-WDC3) APPLICATION (USING DIP SWITCH) ___________________________ 10-17
10.4 DISTRIBUTOR – SPX-DST1 ____________________________________________________________ 10-20