Hitachi PRIMAIDE 1440 - Page 84

3 - 36
(2) Check of time program
Take the following procedure for checking the program that
was set in the above.
Press the
PROG
key.

SET PROGE NO. (1 - 9)
1
Press 1 key and then the ENT key.

EDIT MODE (MODIFY=0, NEW=1)
0
Press 0 key and then the ENT key.
Step at startup is indicated.

TIME Ex Em BASE PMT
0.0 250 350 1 3 1
Press  key to access the next step.

TIME Ex Em BASE PMT
10.0 270 370 2 2 1
Press  key to access the next step.

TIME Ex Em BASE PMT
20.0 1
Press the ESC key, and the 1
st
monitor screen returns.
↓
TIME Ex Em FL PROG LAMP [I]
0.0 250 350 0.0 1 Xe