Hitachi RAS-(3-6)HVRNM2E - Removing Air Outlet Grille; Removing Upper Cover; Removing Outdoor Fan Motor

10 Servicing
362
SMGB0064 rev.0 - 08/2011

Removing air outlet grille
1 Remove the four (4) xing screws.
2 Lift the air outlet grille holding the lower parts.
3 Release the extruded hook of the air outlet grille from the
shroud.
1. Air outlet grille.
2. Shroud.
1
2

Removing upper cover
1 Remove the eleven (11) xing screws.
2 Lift the upper cover upwards.
1. Upper cover.
1

Removing outdoor fan motor
1 Remove the service cover according to the section Removing service cover, see on page 361 in this chapter.
2 Remove the air outlet grille according to the section Removing air outlet grille, see on page 362 in this chapter.
3 Remove the upper cover according to the section Removing upper cover, see on page 362 in this chapter.
4 Disassemble the fan blade by removing the cap nuts and washers xing the fan blade onto the motor shaft.
5 Remove the fan motor connector from the PCN202 at the electrical box.
• Cut off the cable tie that xes the lead wire of the fan motor.
• Remove the four (4) screws that x the motor to the motor clamp.