Hitachi RAS-(3-6)HVRNM2E - Outdoor Units RAS-(8;10)HRNSE

10 Servicing
420
SMGB0064 rev.0 - 08/2011
To mount components be sure to match the wiring connection with the mark band codes.
View from P
10.3.3 Outdoor Units RAS-(8/10)HRNSE

Removing service cover
N O T E
Follow the procedure below to remove main parts and components. For mounting follow the reverse procedure
of removal.
Do not expose the refrigerant cycle to the atmosphere for a long period to avoid moisture or dust entering into
the cycle. Be sure to replace parts immediately after removing. Seal the refrigerant cycle when left unattached for
a long period.
1 Remove the four (4) xing screws slide the service cover
downward and remove.
• Pay attention not to fall of the service cover.
1. Service cover.
1