10 Servicing
373
SMGB0064 rev.0 - 08/2011
10
Removing upper cover
1 Remove all the screws xing the upper cover both on the front
and back of the machine.
2 Lift the upper cover upwards.
1. Upper cover.
1
Removing the lower part of service panel and rear panel
1 Remove the ve (5) xing screws at the lower part of the servi-
ce panel and remove the lower part of the service panel by pu-
lling towards the front side. Remove the upper cover according
to section Removing upper cover, see on page 373 in this chapter.
1. Air outlet grille.
2. Rear cover.
3. Lower part of service cover.
4. Fixing portion for outdoor temperature thermistor.
5. Air inlet grille (rear side).
6. Pull.
1
2
2
3
4
5
6
N O T E
• The length of xing screws for the outdoor temperature thermistor is different than all other screws in the
machine as an assembly poka-yoke.
Removing outdoor fan motor
1 Remove the service cover according to the section Removing service cover, see on page 372 in this chapter.
2 Remove the air outlet grille according to the section Remove air outlet grille, see on page 372 in this chapter.
3 Remove the upper cover according to the section Removing upper cover, see on page 373 in this chapter.
4 Disassembly the fan blade by removing the cap nuts and washers xing the fan blade onto the motor shaft.
To Next Page
Loading...
