Hitachi RAS-3-HVNC - Page 45

2. Unit Installation
31
SMGB0079 rev.0 - 01/2013
2

Wind guard
Specications
Model WSP-264
Quantity 1 per unit
1
2
1 4-6x10 Long Hole
2 5 (Both Sides) - M5 Screw (attachement)
Material Galvanized sheet metal + baked painting
Color UTOPIA Beige
Weight 4.0 kg
Accessories
Fixing screw x 4 [M5 (SUS) x 30]- Unit
Fixing Screw x 10 [M5 (SUS) x 12]- Wind Ward
Installation manual
Installation
restriction
“Guard net” “Air ow guide” or “Snow protection hood” is
not available to install with Wind guard
Attaching example of air wind guard
• Attach the air ow guide to the air discharge grille with four (4) screws (supplied).
• The xing holes are located at 4 positions on the grille. (Screw tightening torque 2.4 3.1 N.m)
• Do not remove the air discharge grille for air ow guide installation.
C A U T I O N
• Iftheairguideisinstalledwithoutdischargegrilleitmaycauseinjuryduetorotatingfan.
Two windguard covers installation
1 Air discharge grille
2 Outdoor unit
3 M5 xing screw x4 (Accessories)
1
1
2
3
Service space
• Both sides of the outdoor unit should be open.
• No obstacles should be placed in the air discharge side.
1 Min.150 mm
2 Outdoor unit
3 Wind guard
1
2
3