Hitachi RX - Page 111

6-6 ●Replacing the ink
Insert the tip of the print head into a beaker.
● Prepares for bending of the ink stream.
8
Press Start/Continue .
● After a while, ink is ejected from the nozzle. Check the position of the ink stream.
● When you want to stop the operation, press Abort .
● When abort processing was performed, select “Ink refill” from the Circulation control screen and
execute.
9
At the end of operation, the screen returns to the Circulation control screen.
10
Display the Operation management screen and set the Ink operating time to “0”.
11
MAX
1LREFILL
MAX line
Fill the reservoir with new ink.
● Be sure not to exceed the MAX line.
7
Cap
Sensor-block
Remove the cap and sensor-block, then drain the ink remaining in the ink reservoir.
● Clean the inside of the reservoir with makeup.
6