6.12 Draining ink from the main ink tank
● When the main ink tank full fault is generated, the ink cannot be drained by screen operation. Drain the ink
and refill with new ink as follows:
Pull out the circulation system.
1
Remove the recovery block and the sensor-block from the main ink tank and
drain the ink for about 100ml from inside the tank into a beaker.
2
Return the circulation system to its original state and display the Circulation
control screen and press the Ink refill → Start/Continue .
*Note that if operation is started without refilling the ink, a “Replenishment Time-out”
fault will be generated.
3
● If the ink is accidentally spilled, quickly wipe if off with wiping paper, etc.
In addition, do not close the maintenance cover until you confirm that the wiped part
is completely dry.
CAUTION
To Next Page
Loading...
