●Ink stream alignment 6-11
Loosen the screw.
Print head cover
Pull out.
6.5 Stream alignment
This operation is performed when the nozzle or nozzle orifice has been replaced. Ordinarily, ink stream
alignment is unnecessary.
● Adjust the stream position so that the stream ejected from the nozzle is at the center of the gutter.
● Adjustment in 2 directions, horizontal direction and vertical direction, is necessary.
Remove the print head cover in the stop state.
1
At the Circulation control screen, press the Ink stream alignment →
Start/Continue .
● Perform this operation with the print head tip inserted into a beaker.
2
● Wear protective gear (goggles and mask).
● If the ink or makeup gets in your eyes or mouth, immediately rinse with warm water and consult a
doctor.
● Perform work after confirming that there is no one in the ink ejection direction.
(Perform this work by inserting the print head tip into a beaker, etc.)
WARNING
Press the Ink stream alignment → Start/Continue and confirm that bending of
the stream and clogging of the nozzle have been repaired.
● Perform this operation with the tip of the print head inserted into a beaker.
● When the ink stream is way outside the gutter, cleaning of the nozzle orifice may not be sufficient.
Disassemble and clean the nozzle orifice again.
● When the ink stream position has deviated from the center of the gutter, adjust it in accordance
with par. “6.5 Stream alignment”.
4
To Next Page
Loading...
