Suction ends in about 1 minute and the screen returns to the Circulation
control screen.
● To stop operation, press Abort .
4
Check if ink stream bending or nozzle clogging has been repaired.
● Display the screen after the Circulation control screen.
5
With the print head cover removed, press the Ink stream alignment →
Start/Continue to eject the makeup.
● Perform this work with the print head tip inserted into a beaker.
6
Confirm that the stream is in the center of the gutter.
● Confirm the stream position from the horizontal direction and vertical direction of the print head
as shown in the figure.
7
● If the ink stream is not in the center of the gutter, perform nozzle backwash again.
If the stream is not corrected even after the nozzle backwash has been performed 3 times,
perform par. “6.4.2 Nozzle orifice disassembly and cleaning”.
At the end of confirmation, press Abort and stop ejection of the makeup.
8
To Next Page
Loading...
