Hitachi RX - Page 120

●Replacing the ink filter 6-15
Parts usage time mgmt. 2015.07.0712:45
Back
Com=0
[Stop

]
Ink filter
Makeup filter
Recovery filter
Air filter
Viscometer filter
MV9 filter
（
hours
）
０００００
０３３３３
０６６６６
０１０００
０１０００
＜Consumption＞
Ink
Makeup
Print count
Update log
2015/03/22 08:15
００１０００ (ml)
００１０００ (ml)
０００００１０００
Pump
Heating unit
ＭＶ１
ＭＶ２
ＭＶ３
ＭＶ４
ＭＶ５
ＭＶ６
ＭＶ７
ＭＶ８
ＭＶ９
ＭＶ１１
 （hours）
０１０００
０１０００
０１０００
０１０００
０１０００
０１０００
０１０００
０１０００
０１０００
０１０００
０１０００
０１０００
０００００
０１０００
０１０００
０１０００
HOME
The joints cannot be installed if the installation position of the piping is incorrect.
(C is at the center of the ink filter and D is at the outside.)
When installing, always lock piping joints C and D by turning them clockwise.
A small amount of ink will remain inside the ink filter even after ink drainage.
Be careful that the ink does not spill when handling the used ink filter.
CAUTION
Set the ink filter at the holder.
● When Start/Continue is pressed, refilling of the lines with ink begins.
● After a while, ink is ejected from the nozzle. Check the position of the ink stream.
● Confirm that there is no ink leaking from the piping joints of the replaced ink filter.
● When operation was aborted, execute “Ink refill” from the Circulation control screen.
5
Return the reservoir base to its original position.
6
Close the maintenance cover.
7
Open the Parts usage time mgmt. screen (menu 2 of the Circulation control
screen), and set the Ink filter time to “0”.
8
2
1
3