Hitachi RX - Page 138

●Long-term Shutdown 6-33
Circulation control
Select option; press [Start/Cont.] Proc. status:
2015.07.0712:45
Com=0
[Stop ]
Ink drainage
Ink refill
Circulation system
cleaning
Pressure relief
Ink stream
alignment
Cancel
Start/Continue
Parts usage time
management
Circulation system
environment setup
HOME
Prev.Dsp.
NextDsp.
Recovery-line
operation check
Viscometer
calibration
B
B
Open the "Circulation control" screen, and press the
Recovery-line operation check key and then the Start/Continue key.
4
Start/Continue
Follow the operation guidance on the screen.
● Open the print head cover and place the opened head into the beaker to pour the makeup in the
gutter.
● Follow the operation guidance on the screen to pour the makeup in the gutter.
●The recovery path is operating normally if the makeup flow is confirmed in Tube B after the makeup
is poured in the gutter.
5
Cleaning bottle
Beaker
Gutter
Tube B
An ink fixing may be caused if the makeup flow in Tube B is NOT confirmed.
For restoration, a special work is required. Contact the local distributor nearest to you.
CAUTION
The operation checks before conducting "Process after long-term shutdown" is completed .
If the printer does not operate normally after the procedures explained above, abort the operation.
A special work is required for the restoration. Contact the local distributor nearest to you.