Hitachi RX - Page 62

●Transmission Sequences 5-16
● Target sensor filter
ESC2 Header 25H
Classification
40H
Division
Division (1:time setup, 2:until end of print)
● Target sensor filter setting value
ESC2 Header 25H
Classification
41H
1000s place 100s place 10s place Units place
Value (0000 to 9999)
● Two or more print specification items can be consecutively transmitted in a single chain.
ESC Header 30H 10s place Units place
●Character height
ESC Header 31H 100s place 10s place Units place
Character width (000 to 199)
● Character width
ESC Header 35H 1000s place 100s place 10s place Units place
●Repeat count
Repeat count (0000 to 9999)
ESC Header 34H 1000s place 100s place 10s place Units place
●Repeat intervals
Repeat intervals
(0000 to 9999)
ESC Header 33H 1000s place 100s place 10s place Units place
● Print start delay
Print start delay (0000 to 9999)
Character height (00 to 99)
ESC Header 36H 1000s place 100s place 10s place Units place
● Print start delay (reverse)
Print start delay (reverse) (0000 to 9999)
ESC Header 37H 100s place 10s place Units place
●Target sensor timer
Target sensor timer (000 to 999)
ESC Header 38H 1000s place 100s place 10s place Units place
●Target sensor filter
Target sensor filter (0000 to 9999)
ESC Header 39H Division
Division (1:time setup, 2:until end of print)
●High-speed printing
ESC Header 3AH Mode
Mode (0:HM, 1:NM, 2:QM)
ESC Header 3CH 100s place 10s place Units place
●Pulse rate division Factor
Pulse rate division Factor (001 to 999)
ESC Header 3DH 10s place Units place
●Ink drop use percentage
Ink drop use percentage
(01 to16)
[Existing machine message] Existing machine message can also be used.
ESC Header 32H Units place
Character orientation (0 to 3)
● Character orientation
●Product speed matching
ESC Header 3BH
Character
orientation
Product speed matching (0:Time-based, 1:Encoder based)